Considered Vincent Parts

We are taking a look at making the following parts. "Sometimes the magic works, and sometimes it doesn't." Chief Dan George, LITTLE BIG MAN.

All of my parts interchange and fit with original parts.

FT263 - CRASHBAR LUG, 4 used - mold made

After these are made, the complete CRASHBAR ASSEMBLY

G83/1 - Left Hand Kickstarter Shaft

FT208AS - BRAMPTON FORK LEG - OEM part in a fixture - molds made

These will be heavier than the original 8 1/2 pound part. Lost Wax, 4140 Chromoly steel main 4 castings give great detail and strength.

FT207S - BRAMPTON FORK LOWER TRIPLE TREE - mold made

These will be heavier than originals. Lost Wax, 4140 Chromoly steel main 4 castings give great detail and strength.

SIDECAR ADAPTER, REAR - mold not made

Attaches to Pillion Footrest Support Plate.

ET176/1 - DYNAMO CLAMP - mold not made

For use with the ET202 DYNAMO ADAPTER 3".

FT3 - CYLINDER HEAD BRACKET (Rear)- mold not made

Earlier models used these as fronts. Closed type. Lost Wax, cast 4140 Chromoly steel gives great detail and strength.

Twins.

FT3/2 - CYLINDER HEAD BRACKET (Front)- mold not made

Open slotted type. 1951 and later machines with "earless" steering head lug. Lost Wax, cast 4140 Chromoly steel gives great detail and strength.

Twins and Singles.

ET32/2 - CARBURATOR ADAPTER, Rear, 1 1/8"- mold not made

Shadow carb adapter. Bronze, as per originals.

ET32/3 - CARBURATOR ADAPTER, Front, 1 1/8"- mold not made

Shadow carb adapter. Bronze, as per originals.

FT9L - REAR FRAME MEMBER AXLE PLATE, Left- mold not made

4140 chromoly steel casting.

FT9R - REAR FRAME MEMBER AXLE PLATE, Right- mold not made

4140 chromoly steel casting.

FT10/1 type 1 - REAR STAND LUG, type 1- mold not made

4140 chromoly steel casting. The early version with the lip around the edge of the forging.

ET84/2 - EXHAUST PIPE NUT, 2"- mold not made

Bronze casting. 2" pipes and a Left Hand Kicker, for Specials.

FT213R - BRAMPTON UPPER RIGHT LINK- mold not made

3 3/8", 7/16" CEI RH thread.

FT213L - BRAMPTON UPPER LEFT LINK- mold not made

3 3/8", 7/16" CEI LH thread.

FT200 - BRAMPTON LOWER RIGHT LINK- mold not made

1/2" CEI RH thread.

FT213L - BRAMPTON LOWER LEFT LINK- mold not made

1/2" CEI LH thread.

F24 - SERIES A PROP STAND, EXTENDED- mold not made

Made to achieve proper lean angle.

F52/13 - COMET FOOTREST HANGAR, Right- mold not made

As per Vincent supplied originals.

F52/13F - COMET FOOTREST HANGAR, FOLDING, Right- mold not made

To be used with F72/1 Footrest.

F52/14F - COMET FOOTREST HANGAR, FOLDING, Left- mold not made

To be used with F72 Footrest and original Comet Brake Cable.